Canaon Sure Shot A95 Problem: Dropped on Floor

Discussion in 'Digital Cameras' started by mstrspy, Dec 26, 2006.

  1. mstrspy

    mstrspy Guest

    My daughter's Canon A95 was dropped on a hard surface. The only damage
    that I see is the clip that holds the strap has broken off and the top
    piece that houses the zoom switch and shutter release is lifted. I
    tried pressing it back and looks like it should snap on but it won't.
    It looks like I can pry the entire piece off and look at what is
    hanging it up. If I do this, will I end up with a bunch of loose parts
    that will be dificult to reassemble? Anyone here have experience with
    this camera? By the way, it still works , but I think that the
    seperation of the case may become a problem.
    mstrspy, Dec 26, 2006
    1. Advertisements

  2. mstrspy

    DHB Guest

    She should consider herself very lucky, most such run-ins with gravity
    don't do as well. This is why P&S cameras come with a wrist strap &
    should *always* be used, especially true for the smaller P&S cameras.

    The canon A95 is held together with several small Philips screws so I
    would not try to pry it open without 1st removing the appropriate
    screws. If you remove the correct 1's, you may be able to remove &
    properly replace the panel. Someplace I recall seeing step-by-step
    photo guide that shows which screws to remove & replace to disassemble
    & reassemble it. In your case you hopefully just need to know which
    screws to loosen/remove & then reinstall them in order to get it back
    together correctly.

    Search the Internet & hopefully you find it & it will help.

    Only you can answer this based on seeing what is involved & if you
    think it's something you can handle. Don't even try it without a
    precision Philips screwdriver of the correct size, good lighting & a
    very clean work area. Also a local camera repair shop might be worth
    getting a cost estimate from especially since this is likely a very
    simple repair for them & they will have the correct tools.

    Best of luck, do try to find the photo disassembly guide if your
    considering tying this. If I come across it again, I'll post it.

    Respectfully, DHB

    "To announce that there must be no criticism of the President,
    or that we are to stand by the President, right or wrong,
    is not only unpatriotic and servile, but is morally treasonable
    to the American public."--Theodore Roosevelt, May 7, 1918
    DHB, Dec 27, 2006
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.