Data rate on drive C: less than required rate - Pinnacle studio 7 - HELP !!

Discussion in 'Amateur Video Production' started by Tufty, Aug 23, 2003.

  1. Tufty

    Tufty Guest

    Just purchased a new PC (p4 2.6Ghz, 1gb Memory, 160gb seagate Hard
    drive....etc) and when trying to use Pinnacle Studio 7 it tells me
    that 'The data rate is less than the required rate of 4444
    kbytes/second.
    Checked the transfer rate on the device manager and currently they are
    set to DMA if available but currently device 0 is set to PIO and I
    cannot change this.
    Any ideas on how to change this to permenant DMA and will this fix
    this issue ??
    Any other ideas gratefully received.
    Cheers,
     
    Tufty, Aug 23, 2003
    #1
    1. Advertisements

  2. Tufty

    Roly Guest

    Uninstall the primary IDE controller from Device Manager and reboot. It
    should reinstall in DMA mode.
     
    Roly, Aug 23, 2003
    #2
    1. Advertisements

  3. Tufty

    nappy Guest

    yes.. you probably are not in DMA mode BUT.. you should not be using your C:
    drive to store your data. It should be on a seperate drive
     
    nappy, Aug 23, 2003
    #3
  4. Tufty

    Tufty Guest

    Thanks for all the messages on this. I installed a new/updated IDE
    driver and then re-booted and now the hard drive is in Ultra-DME mode
    and the Pinnacle Studio capture rate now works fine.
     
    Tufty, Aug 25, 2003
    #4
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.