Electronic cable release for Ricoh Mirai ???

Discussion in 'Ricoh' started by headrippa, Feb 16, 2004.

  1. headrippa

    headrippa Guest

    Gday everyone,

    Would anyone know where I could buy one of these for my Mirai ? I've
    searched almost everywhere and so far have not found one.

    Thanks to all who reply

    HR
     
    headrippa, Feb 16, 2004
    #1
    1. Advertisements

  2. headrippa

    Duncan Ross Guest

    It's easy to make one. The cable release is just a 2.5mm jack plug at one end
    of a cable with a push-switch at the other.

    I made one out of a 35mm film case, I put a red pushbutton at the closed end
    and a 2.5mm socket on the side. Inside I kept a cable with a 2.5mm connector at
    each end. When I needed it I popped the top off, took out the cable, plugged
    one end into the camera and the other into the socket.

    There you go, another use for a 35mm pot.
     
    Duncan Ross, Feb 16, 2004
    #2
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.