Firmware & Flash (s602z)

Discussion in 'Digital Cameras' started by PhAnTOmaS, Jun 20, 2004.

  1. PhAnTOmaS

    PhAnTOmaS Guest

    1) I'm looking for fuji s602z firmware, or do some "trick" that allow to use
    camera flash, and a hot-shoe at same time
    2) Looking for a good flash on fuji s602zoom [think that TTL is not allowed
    :( ], about 50 or 100 $. Don't want an expensive flash 'cause no mo' and
    wanna learn to use it. Good power, and light distribution.

    f on my digital camera goes from 2,8 to 11

    thanks
     
    PhAnTOmaS, Jun 20, 2004
    #1
    1. Advertisements

  2. PhAnTOmaS

    Tony Spadaro Guest

    Why not just put a slave on a flash unit and it will be fired by the built
    in?
     
    Tony Spadaro, Jun 20, 2004
    #2
    1. Advertisements

  3. PhAnTOmaS

    PhAnTOmaS Guest

    *_+

    ouch
    I have no notice about that.
    How much does it cost? I'm just looking for "normal" flashes 'cause was
    thinking out of hot-shoe is everything expensive.... but there are some
    hot-shoe... omg. Metz 40 MZ-2 is about 300$, anyway can flash directly and
    rebound

    Got you any predilected flash?

    thx
     
    PhAnTOmaS, Jun 20, 2004
    #3
  4. PhAnTOmaS

    PhAnTOmaS Guest

    *_+

    ouch
    I have no notice about that.
    How much does it cost? I'm just looking for "normal" flashes 'cause was
    thinking out of hot-shoe is everything expensive.... but there are some
    hot-shoe... omg. Metz 40 MZ-2 is about 300$, anyway can flash directly and
    rebound

    Got you any predilected flash?

    thx
     
    PhAnTOmaS, Jun 20, 2004
    #4
  5. Fuji does not have firmware updates.
     
    Peter A. Stavrakoglou, Jun 20, 2004
    #5
  6. PhAnTOmaS

    Tony Spadaro Guest

    I'm not much of a flash shooter and use a flash meter so mine are manual,
    but slave units can be had for as little as 20 dollars in the US.
     
    Tony Spadaro, Jun 21, 2004
    #6
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.