Jobo reel issue--2 rolls 120 on the spool but a problem!!

Discussion in 'Darkroom Developing and Printing' started by Jos. Burke, May 29, 2005.

  1. Jos. Burke

    Jos. Burke Guest

    Alrighty--Using my Jobo 120 spools which accomodates either 2 rolls of 120
    or a single 220 I have an issue of a small area of one of the rolls not
    being fixed properly. Note this is for B&W film!! I can go back and refix
    the one frame or two halves but can I simply avoid this problem???--Any
    suggestions--Yes I realize I can just load a single roll of 120 on the spool
    but occasioally that presents a problem and it would be nice to use the two
    rolls on the one spool as a matter of convenience more than that of
    economy!!
    Any tricks of the trade to share??
    Joseph Burke
     
    Jos. Burke, May 29, 2005
    #1
    1. Advertisements

  2. Jos. Burke

    Nick Zentena Guest

    Which ones?
    This isn't an overlap issue I guess? If it is are you pushing the red clip
    down between the two rolls? If it isn't an overlap issue could you describe
    the problem better. Is it always the same spot on the roll? Or does it vary?

    Nick
     
    Nick Zentena, May 29, 2005
    #2
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.