Mounting a Dichro DG head to a Beseler CB-7?

Discussion in 'Darkroom Developing and Printing' started by Nick Zentena, Aug 26, 2005.

  1. Nick Zentena

    Nick Zentena Guest

    I got a good deal on a Dichro head. Beseler no longer makes the
    adapter to mount the head to the CB-7. Of course I've never seen the adapter
    either. So any hints? From just resting the head on the enlarger it seems
    all the adapter would do is provide a smaller hole. My first thought was
    plywood but I'm worried about dust. Also any ideas for mounting the power
    supply? If it had a longer cord I could just leave it next to the enlarger
    but it's short enough that it looks like I'll need to mount it to the head.
    The connector from the head to the power supply is a five pin plug. Likely
    not something I can pick an extension cord for.

    Thanks
    Nick
     
    Nick Zentena, Aug 26, 2005
    #1
    1. Advertisements

  2. Nick Zentena

    Nick Zentena Guest


    I figured out the power supply. Thanks to Ebay and it's picture
    collection. AKA auctions. The spacer seems simpler then I thought to.

    Nick
     
    Nick Zentena, Aug 26, 2005
    #2
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.