Photoshop for CAD

Discussion in 'Photoshop' started by Des, Jan 21, 2011.

  1. Des

    Des Guest

    Sorry this was originaly posted to photoshop.apps. not the correct
    group.

    Hi I need a bit of help with drawing capabilities in Photoshop 7

    I need to do a template of a house. The roof section is on an angle
    of
    30 degrees. I can create a rectangle of 2875 pixels width by 200
    pixels high. What I want to do is slice it from top right to bottom
    left leeaving me with a triangle. There is a slice tool in Photoshop
    7
    but never used it. Can anyone help here as I could use photoshop to
    lay things out here.


    Thanks.


    Desmond.
     
    Des, Jan 21, 2011
    #1
    1. Advertisements

  2. Draw a square the width of half the roof.
    Rotate 60*, used the rectangular selection to crop off the unwanted part.
    Rotate back, position, duplicate and flip horizontal.

    Of course there -=are=- free CA programs out there!
     
    Sir F. A. Rien, Jan 21, 2011
    #2
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.