Primefilm 1800 problems

Discussion in 'Scanners' started by gja1, Feb 10, 2004.

  1. gja1

    gja1 Guest

    I had used this scanner to archive about 1500 slides and it was working
    fine at that time. I just tried to use it again and got a software
    lockup and a message saying possible lamp or ccd failure. This occurs
    when it is warming up. I've tried two drivers from scanace and one gets
    past this point and scans but there is no picture there. Has anyone else
    had this problem and what would it cost to replace a ccd or lamp? Any
    input would be appreciated.
     
    gja1, Feb 10, 2004
    #1
    1. Advertisements

  2. gja1

    John Guest

    I've had a lot of problems with the 1800. I took 2 of them back to the
    store. I liked the output, but the lamps kept failing.

    I've used the 3rd one only one time. I'm afraid it'll be dead the next time
    I try to fire it up.
     
    John, Feb 11, 2004
    #2
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.